G10 and FR4 laminate parts waterjet cut, machined and fabricated

G10 and FR4 are very similar products, they are basically glass fiber laminated into sheets and we can waterjet cut it, machine it and fabricate with it to make your parts and assemblies.
G10 and FR4 are a composite sheet material in the GRP  / glass fiber laminate range.
We have made many parts from this composite material and it’s equivalent.
G10 is used in electronics, aviation, marine etc.. where a lightweight strong material is required.

a set of parts made from G10 and glass fiber angle with threaded brass inserts.

the G10 parts assembled

finished in a special Nato paint for MOD use

This is a sample part showing the small holes we are potentially able to cut
with waterjet this part is approximately 30mm x 30mm

Another small part waterjet cut in FR4 the centre hole is approximately 20mm in diameter

A stack of G10 parts each 5mm thick being prepared for painting.

Some large rings waterjet cut to 410mm o/d from G10 laminate sheet material

G10 sheet waterjet cut for a switch panel.

G10 FR4 epoxy glass fiber laminate 10mm thick sheet waterjet cut into parts

Yacht mast frame components waterjet cut from G10 epoxy glass laminate 5mm thick sheet

Variouse

Share on facebook
Share on google
Share on twitter
Share on linkedin
Share on pinterest
Share on facebook